Search

Jumat, 30 Maret 2012

Is it pushing or pulling?

I'm starting to piece together the story of how the fields and currents interact in an induction motor. Last time I left off with this picture, showing the stator currents on top and the rotor currents on the bottom. The stator field is presumed to be moving from right to left oops! I meant left to right!:

This is how the field ought to look when the motor is starting. You can see that the maximum rotor current is flowing in a region where there is not much magnetic field. That's why even though there is a lot of current flowing, it's not very effective in creating torque. Another, more oblique way of putting it, is to say that because of the high slip frequency, the rotor current is mostly inductive.

As the motor comes up to speed, the slip frequency approaches zero, and the rotor current becomes more resistive than inductive. That means its phase relative to the stator shifts by as much as 90 degrees. This picture shows the rotor current near synchronous speed:

You can see that now the rotor current is flowing in a region where the magnetic field is strong. So it is effective in creating a lot of torque. Won't the maximum torque be created when the rotor current is exactly half way between, where the strongest field is located?

Actually, no. There are two things happening here at the same time. The phase is controlled by the slip frequency: as the slip frequency goes from zero to infinity, the reactance of the rotor goes from pure resistive to pure inductive, which means the phase shifts through 90 degrees. The most favorable torque occurs in pure resistive conditions, when the slip is zero, and the rotor current flows in the middle of the strongest magnetic field.

But that's only half the story. As the slip frequency decreases, the effective rotor voltage also decreases, going all the way to zero when the rotor reaches sychronous speed. So although the phase angle is most favorable, the current is now zero. The current increases with rotor voltage, which is directly proportional to slip frequency.

Where is the optiumum? It's one of those typical compromise situations where the maximum torque occurs at a phase angle of 45 degrees, or in other words, at that slip frequency where the resistive and inductive components of the rotor reactance are equal. That's when the motor develops its maximum torque. It's funny that from my pictures, it appeas that the currents are pushing on each other more than they are pulling. (Remember that when it comes to electric currents, opposites repel.)

But as Colombo used to say, there's just one thing still bothering me. I have a nice set of pictures, with the relative phases of rotor and stator current going through 90 degrees over the full range of operating conditions...this lines up with the idea of inductance vs. resistance. But am I quite sure I'm using the right pictures? Here's another picture that suggests a different mode of operations:

Here I'm showing the rotor currents lagging the stator instead of leading, and I've reversed the polarity so instead of repulsion I'm getting attraction between adjacent windings. (Like attracts like.) How do I know I haven't confused myself, and this isn't the true picture of how a motor works?

I find this a very hard question, but there is one way I can look at it that makes me fairly confident of what is the right answer. Oh, I know I can supposedly do those "right hand rule" tricks where I point my thumb along the direction of current flow and curl my fingers this way or that, but really now. If you're relying on that kind of stuff to tell you what's happening in a physical situation, you're obviously lost. You really need to argue from physical realities, and it's not that easy in this case. I think I have the right answer, but I'm going to leave it for next time.



Tidak ada komentar:

Posting Komentar